HELP !

Shooting the bull on historic motor racing and motorsport history.
User avatar
Chris Read
Journeyman Racer
Posts: 103
Joined: Wed Feb 29, 2012 8:59 pm
Location: Arrowtown, Central Otaaaaaaago

HELP !

Post by Chris Read »

BCM Conrod bolt 001.jpg

You probably have gathered that I am better at racing cars than fixing them. This is a con rod bolt out of my BCM motor which is a 6 cyl Vauxhall 2.2L PA S (1957).
It is not Vauxhall as when it was re built we did not use Vauxhall rods.
The bolt is 52mm from under the head to tip of thread, has a 5/16 shaft to a 5/16 UNF thread.
Where do I go to get 12 replacements?
Someone said ARP in the States but does anyone in NZ supply or source bolts?

Any response appreciated.

Also if anyone has a PA motor under the bench then my hand is up as I am running out of bits - down to my last head and current block is out +60 thou.
Chris Read - Arrowtown
wynna7
Weekend Warrior
Posts: 7
Joined: Fri Jul 08, 2011 10:43 pm

Re: HELP !

Post by wynna7 »

Chris Read wrote:[ATTACH=CONFIG]10743[/ATTACH]
You probably have gathered that I am better at racing cars than fixing them. This is a con rod bolt out of my BCM motor which is a 6 cyl Vauxhall 2.2L PA S (1957).
It is not Vauxhall as when it was re built we did not use Vauxhall rods.
The bolt is 52mm from under the head to tip of thread, has a 5/16 shaft to a 5/16 UNF thread.
Where do I go to get 12 replacements?
Someone said ARP in the States but does anyone in NZ supply or source bolts?

Any response appreciated.

Also if anyone has a PA motor under the bench then my hand is up as I am running out of bits - down to my last head and current block is out +60 thou.
Chris Read - Arrowtown


I source all my ARP products from Segedins, 381 Dominion Rd, Kingsland, here in Auckland. Ph 09 638 6439.
User avatar
Chris Read
Journeyman Racer
Posts: 103
Joined: Wed Feb 29, 2012 8:59 pm
Location: Arrowtown, Central Otaaaaaaago

Re: HELP !

Post by Chris Read »

Will give them a go - thanks, Chris
kennycooper
Weekend Warrior
Posts: 8
Joined: Tue Jul 30, 2013 4:18 am

Re: HELP !

Post by kennycooper »

wynna7 wrote:I source all my ARP products from Segedins, 381 Dominion Rd, Kingsland, here in Auckland. Ph 09 638 6439.


Chris,

I am in Adelaide South Australia and into Vauxhalls - especially early stuff.
I have a contactwho has E model stuff - Should be able to source an engine if you need it

BTW I have always been interested in the BCM and also the earlier Maybey 14 Vauxhall special - have you any shots or details (specs) of the car out of interest - There are photos of the BCM but not the earlier car

cheers,

Lachlan Kinnear
Adelaide
mailto:?subject=&body=
Post Reply