One of the very few period New Zealand built Formula Juniors was the Valour driven by Jim Boyd.
Eventually the car was parted with components being used in the Edbry Ford and the Maral Sports. Currently some parts have been gathered together with the intent of reconstructing the original car. Any information or parts would be appreciated.
The photo below from early 1964 at an unknown venue shows the Valour with the Lola Mk2 (Morrie Smith?) #26.
Valour Single Seater
-
- Journeyman Racer
- Posts: 87
- Joined: Tue Nov 29, 2011 11:34 pm
Re: Valour Single Seater
The Edbry Ford was merely the rebodied Valour which was done by John EDwards and Larry BRYant. Somewhere along the line the original wheels were replaced with wider ones. I bought it from them and raced it until I replaced it with the Graeme Baker/ Allan Rhodes BT21a. My third meeting at Teretonga I rolled it (Long story for another time) and consequently re-rebodied it again. I sold it to Mark Lamberton who later built a two seater chassis and body to convert it to the SCANZ 2 litre Maral Sports. I did the same thing with my BT21a. I have some photos somewhere I think of all the rebodied versions.
Re: Valour Single Seater
Hay there HIGH POCKETS so thats were it went had A little ride in it when Jim Boyd was on the seen Jamie A
Re: Valour Single Seater
Is this the Edbry Ford?
-
- Journeyman Racer
- Posts: 87
- Joined: Tue Nov 29, 2011 11:34 pm
Re: Valour Single Seater
Sure is Roger. That's how it was when I bought it. As you can see, flat alloy panels riveted to a simple, lightish steel tube frame welded to the original Valour chassis. The mirror and the quite strong side panel did my head and face no good at all when it was wedged between that and the track. Result six weeks in hospital for facial injuries. No major damage to the car! Those rear wheels were 10" steel with gussets and weighed a ton! Quite a quick car, was never beaten by another pushrod Ford whilst I had it, except when I had the odd DNF.
-
- Semi-Pro Racer
- Posts: 736
- Joined: Tue Apr 26, 2011 8:19 am
- Location: London, England
Re: Valour Single Seater
Russ Noble wrote:...flat alloy panels riveted to a simple, lightish steel tube frame welded to the original Valour chassis.
So reports that Edwards and Bryant built a new chassis are wrong?
(Can't remember where I read that)
-
- Journeyman Racer
- Posts: 87
- Joined: Tue Nov 29, 2011 11:34 pm
Re: Valour Single Seater
David McKinney wrote:So reports that Edwards and Bryant built a new chassis are wrong?
I'm pretty sure, but its over 40 yrs ago...... I ran into John Edwards for the first time in ages last month. I can always look him up and see if he can confirm that.