HELP !

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:) :o :D ;) :p :mad: :confused: :( :rolleyes: :cool: :eek:
BBCode is ON
[img] is ON
[url] is ON
Smilies are ON
Topic review
   

Expand view Topic review: HELP !

Re: HELP !

by kennycooper » Tue Jul 30, 2013 5:40 am

wynna7 wrote:I source all my ARP products from Segedins, 381 Dominion Rd, Kingsland, here in Auckland. Ph 09 638 6439.


Chris,

I am in Adelaide South Australia and into Vauxhalls - especially early stuff.
I have a contactwho has E model stuff - Should be able to source an engine if you need it

BTW I have always been interested in the BCM and also the earlier Maybey 14 Vauxhall special - have you any shots or details (specs) of the car out of interest - There are photos of the BCM but not the earlier car

cheers,

Lachlan Kinnear
Adelaide
mailto:?subject=&body=

Re: HELP !

by Chris Read » Tue Sep 04, 2012 11:14 pm

Will give them a go - thanks, Chris

Re: HELP !

by wynna7 » Tue Sep 04, 2012 8:37 pm

Chris Read wrote:[ATTACH=CONFIG]10743[/ATTACH]
You probably have gathered that I am better at racing cars than fixing them. This is a con rod bolt out of my BCM motor which is a 6 cyl Vauxhall 2.2L PA S (1957).
It is not Vauxhall as when it was re built we did not use Vauxhall rods.
The bolt is 52mm from under the head to tip of thread, has a 5/16 shaft to a 5/16 UNF thread.
Where do I go to get 12 replacements?
Someone said ARP in the States but does anyone in NZ supply or source bolts?

Any response appreciated.

Also if anyone has a PA motor under the bench then my hand is up as I am running out of bits - down to my last head and current block is out +60 thou.
Chris Read - Arrowtown


I source all my ARP products from Segedins, 381 Dominion Rd, Kingsland, here in Auckland. Ph 09 638 6439.

HELP !

by Chris Read » Tue Sep 04, 2012 1:03 am

BCM Conrod bolt 001.jpg

You probably have gathered that I am better at racing cars than fixing them. This is a con rod bolt out of my BCM motor which is a 6 cyl Vauxhall 2.2L PA S (1957).
It is not Vauxhall as when it was re built we did not use Vauxhall rods.
The bolt is 52mm from under the head to tip of thread, has a 5/16 shaft to a 5/16 UNF thread.
Where do I go to get 12 replacements?
Someone said ARP in the States but does anyone in NZ supply or source bolts?

Any response appreciated.

Also if anyone has a PA motor under the bench then my hand is up as I am running out of bits - down to my last head and current block is out +60 thou.
Chris Read - Arrowtown

Top